In dialogues P -.list and G -.list it is possible to produce cleaning sheets. For this it is necessary to cause by the right knob of the mouse of the menu of sheet and to harvest point "Clear".
During cleaning P -.list automatically is cleaned G -.list and Track-.list. Cleaning G -.list does not influence contained P -.list and Track-.list.
Actions->.Quick Clear – For eliminating Unc- the errors, not caused by the physical surface damage
Initsializatsionnye files
File HDD..INI
Section [ SConner ] determines name for the files of resources.
Key Resource name format assigns the size of name for the resource. Size can be the arbitrary collection of the symbols, in which can be included the following special macrosubstitutions:
? %.l – complete name of accumulator. For example, for accumulator Seagate ST340810A instead of this macro will be substituted ST340810A.
? %.s – short name. For the contemporary accumulators Seagate it does not have sense, but as a whole –will substitute name from the end and to the right-most gap. therefore for already upominavshegos of 4 accumulators will be substituted name ST340810A.
? %.r – version of the micro-code, bear as soon as two first fields of complete version! For polucheni of 4 complete versions of the micro-code it is necessary to look the code of family. It is left for the compatability with other accumulators. Example: rev_3_99.
? %.f – code of family, the complete version of the microprogram of accumulator, unambiguously it is described by 4 within the limits of model. Example: fcode_3_99_200.
? %.n – plant address. It can be useful in the case of guarantee elevation of rata (if you will write all official regions of passing through your hands accumulators). Example: SN5FB8PJTE.
Example of the size of the name: %.l_.fcode _ %.f_.SN%.n
File SConner..INI
Section [ MODELS ] determines the rules of the reference of concrete models to the families. Selection goes on the version of the micro-code. In the standard delivery, all known to the authors versions refer in one and the same section [ U6 ]. If you want to make more detailed division into the families with the more fine adjustment the separation must be produced precisely at this level.
Section [ LOGICAL ] contains the reference book of the standard models of accumulators. It is possible to supplement independently it, adding the names and the logical parameters of necessary models.
Section [ GENERAL ] can contain the base tuning of utility, necessary for the normal operation with accumulators Seagate U6.
Section [ CP LIST ] contains parameter max CP, which determines the number of maximum modulus which will be sokhr of anen in the file of resources. The standard value of this key for Seagate U6 is such:
上一篇：HRT的Seagate Drives U8, V8, U10英文说明书
下一篇：HRT的Seagate Drives Ux英文说明书 |
相关文章